BasicMicroUK - Forums

www.basicmicro.co.uk
It is currently Sun Nov 19, 2017 11:37 am

All times are UTC [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Roboclaw stuck in bootstrap mode
PostPosted: Wed Apr 22, 2015 5:50 am 
Offline
New User

Joined: Wed Apr 22, 2015 5:45 am
Posts: 1
I recently purchased a RoboClaw 2x15A Motor Controller with USB (V4). I've been talking to it over USB and writing python code and everything was working great until for no reason, it started blinking all it's LEDs in quick succession. Another forum says that means it's in bootstrap mode, awaiting new firmware. I then tried downloading the ionmotion software to reload the firmware, but I cannot get my computer to connect to the board. I've installed the drivers and tried everything but I just can't seem to get it to work. Anyone out there with experience using the roboclaw have any suggestions?

thanks.


Top
 Profile  
 
 Post subject: Re: Roboclaw stuck in bootstrap mode
PostPosted: Wed Apr 22, 2015 7:53 am 
Offline
Site Admin
User avatar

Joined: Fri Apr 12, 2013 8:38 pm
Posts: 87
Location: Nottingham, England, UK
HI

Please note that there is now a new forum for the Robo Claw range that you can find here :-http://forums.ionmc.com

I hope this helps,

Many thanks
Dave

BasicMicroUK
www.basicmicro.co.uk


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

phpBB SEO