BasicMicroUK - Forums

www.basicmicro.co.uk
It is currently Sun Nov 19, 2017 11:39 am

All times are UTC [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Switch Configure
PostPosted: Mon Feb 24, 2014 11:55 pm 
Offline
New User

Joined: Sun Feb 23, 2014 10:27 pm
Posts: 1
Hi,

I'm looking to use Simple Serial with an Arduino Uno.

I've been having trouble configuring the roboclaw to function correctly with the Arduino. Based on the manuals and looking through various forum posts, I know the the transmission pins is Arduino Pin 6 and receive is Pin 5. I have the program set to Mode 5 and Option 3. The LB-MB jumper is installed. I have my setup configured exactly like the schematic drawn.

In the manual, the comment in the sketch says "Switch Settings: SW2 = ON and SW5 = ON." I'm not quite sure how to configure the switch settings since it doesn't say in the tutorials. I have a 2x5A v3 roboclaw so I don't even know if I'm using the correct manual at the moment. Thanks for all the help.

- Michael Hsu


Top
 Profile  
 
 Post subject: Re: Switch Configure
PostPosted: Wed Mar 05, 2014 10:09 pm 
Offline
Site Admin
User avatar

Joined: Thu Mar 01, 2001 7:00 pm
Posts: 1316
Location: Temecula, CA
The comments are for the older boards. The latest versions of roboclaw use buttons instead of dip switches to set the different modes. Make sure you use the manual to set your modes.

_________________
Tech Support
Basic Micro - Robotic Technology Evolved


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group

phpBB SEO